Safety Information

For working with Fdrill and Ftap the following safety rules should be obeyed:

Always wear safety goggles.

When working with the flat Fdrill that are used to remove the collar, proper protective clothing and safety goggles should be worn if no safety guard is installed on the machine to protect against flying chips.

The Fdrill is glowing hot initially after use and should not be touched without proper safety gloves or before it has cooled down.

The workpart gets very hot and should not be touched without proper safety gloves or before it has cooled down.

The safety instructions for the recommended parting medium should be obeyed. The safety data sheets will be supplied if needed.

At the start of the flow forming process, the collet chuck should be tightened after 5 to 10 forming operations to prevent the part from slipping or falling out.

Zhuzhou Fdrill Industry and Trade Co., Ltd. Address: Hetang District,Zhuzhou City, Hunan Province, China
Tel :+86-731-22960026 Fax :+86-731-22961166 E-mail:fdrill@fdrill.com Website: www.fdrill.com


Copyright © Zhuzhou Fdrill Industry and Trade Co., Ltd. All rights reserved